For Mazda CX-50 2023-2025 Rear Fender Flare Right Side – Wheel Arch Trim

Description

Rear Right Fender Flare (Wheel Arch Trim) for 2023-2025 Mazda CX-50

If your 2023-2025 Mazda CX-50 needs a new fender flare, this rear right fender flare (wheel arch trim) is the direct replacement to look at first. It is shaped for the CX-50’s factory mounting points on the passenger side, so it is intended to go on the way the original came off.

A flare that is cracked, warped or held on with only a couple of clips can flap at speed and eventually fall off. Swapping in a new fender flare is a simple repair that restores the clean wheel-arch edge on your CX-50. For other vehicles and positions, see our wheel arch flare replacements. It is shaped for the rear wheel opening on the passenger side, so it follows the factory arch instead of a generic curve.

Common signs that the fender flare needs replacing include cracks along the edges, a chalky or faded surface, sections that have pulled away from the body, rattling at speed and missing clips. Leaving damaged trim in place usually makes things worse, because a loose piece can catch the wind, scrape the paint underneath or come off completely on the highway.

Fitment is listed for Mazda CX-50 model years 2023, 2024 and 2025. It is for the passenger side (right) of the vehicle. As always, confirm the part number and trim level against your vehicle before installation. You can also find more replacement parts for Mazda vehicles for this and other Mazda models.

Here is what you get with this rear right fender flare for the CX-50. It attaches with clips at the factory locations. Note that this listing is the wheel arch trim version, so check that it matches the part on your vehicle. This is the right-hand (passenger side) part; the opposite side is sold separately. It is listed for the 2023-2025 Mazda CX-50.

• Vehicle Compatibility: 2023-2025 Mazda CX-50
• Model Years: 2023, 2024, 2025
• Part: Rear Right Fender Flare (Wheel Arch Trim)
• Position: Rear Right (Passenger Side)
• Attachment Type: Clip-On
• SKU: MD-CX50-2325-FL-RR-D

How to Install Your Mazda CX-50 Fender Flare

Installation is usually straightforward. Remove the damaged piece carefully, check that the mounting clips and holes on the body are intact, and clean the area so the new part sits flat. This part uses a clip-on attachment, so in most cases no drilling is needed. Align the new part with the factory locations and press or fasten it into place, working from one end to the other so it seats evenly.

Small trim parts make a big difference to how a vehicle looks and to its resale value. A missing or damaged piece is one of the first things a buyer or appraiser notices, and replacing it restores a clean, complete appearance. Keeping the trim intact also helps protect the paint and body edges behind it from chips and corrosion.

If the other side is also damaged, the matching driver-side fender flare for the CX-50 lets you replace both together for an even, consistent look. Damage in this area often affects nearby parts too, so you may also need the 2023-2025 Mazda CX-50 front right fender flare. If you are not sure about fitment, have your VIN and the number from your original part ready before you order.

Taking a minute to confirm the year, side and part number before ordering avoids delays and gets your CX-50 back on the road sooner.

Choose this fender flare when you want a direct replacement for your Mazda CX-50 rather than a universal part. Confirm the year and side, then add it to your order.